Traction belt

The outer surface of the drum processing errors, sticky material or wear caused by uneven diameter sizes, the conveyor belt to the larger diameter side of the deviation. So-called "big run do not run small." Its force in Figure 4 shows: Fq traction belt to produce a large-diameter side of the moving component Fy, under the action of the force component Fy, an offset belt. In this case, the solution is to clean the surface of the roller sticky materials, processing errors and uneven wear to be replaced down reprocessed plastic bag handling.
Wheel Loader blanking caused by malposition as five pairs of belt deviation, reprinted material blanking at the point position on the conveyor deviation has a very big impact, especially in the upper section of the conveyor and the conveyor in perpendicular to the horizontal projection greater impact. Usually reproduced points should be considered down two belt conveyor relative height. The relative height of the lower horizontal velocity component of the material the greater the impact on the lower side of the belt steel cement silo , while the material is difficult to center. So that the material on the belt cross section deflection, impact force Fc horizontal component Fy eventually lead to belt deviation. If the material is biased to the right, then the belt deviation to the left, and vice versa.